The content of the kit for DUCATI SCRAMBLER was changed.
Added Nipple covered sealing tape and O
ring The surface of the sand blasted rim for
SCRAMBLER is rough. The rough surface of the rim is troublesome.
The double sided tape is not adhered to the rim tightly even though you affix
the tape neatly. So, the instruction says scrape off the
surface of the rim affixed the tape. However, it is not easy to scrape off
the surface neatly. Air leaks can occur since the adhesion of the tape is
weak when it is not enough to scrape off the surface. It is difficult to install the kit when the rims like
2.50MT or 3.00 MT are narrow, the surfaces of the rims are rough and the
depressions around nipples are deep. The content of the kit for DUCATI
SCRAMBLER is improved so that it is easier to install the kit and you can
install the kit surely. The belief process is as follows; Grind the heads of the nipples with
belt sander and so on. Set the rim on the balancer. Scrape off
the rough surface while rotating the rim with the drill. Fix the shaft tightly so that the rim
cannot fall down. We wish if you could have
lathe fitting the rim of 17 inch. Scrape off the surface of the both
sides affixed the tape neatly. Cut O ring in thirds. Put them on the
deep depressions like the above picture.. Put nipple
tapes with fiver (diameter 13 pi) on the nipples. Put Nipple covered sealing tapes on the
nipple tapes so that the nipple covered sealing tapes can cover the
depressions. Affix the tape to the rim. After that,
it is the same as the usual process. Put the protective sheet on the double
sided tape. At this time, it looks thick by the
thickness of the nipple covered sealing tapes. However, the double sided tape
is adhered to the rim completely since the nipple covered sealing tapes are
pushed to the depressions by internal pressure after setting the tire. ͺThe image of the rim after taking off
the tire You donft need to be sensitive to scrapping
off the surface of the rim when installing the kit in this new way. But finish installing the kit neatly
and carefully. Now, the nipple covered sealing tape and
O ring are attached on only the kit for DUCATI SCRAMBLER. However, we sell
the set of Nipple covered sealing tape and O ring as an option. We want you
to try it when you feel worried about installing the kit. Nipple covered sealing tape 40 pieces and O ring set /
Part Number: NCS20-40 / US $20 |