OUTEX CLEAR TUBELESS KIT
Instructions for front rim of BMW R NINE T
Please proceed to 1, after completing the
preprocessing before affixing the all tapes.
(Refer to the instructions included with the
product)
‡@@Affix crescentic sheets with nipple tapes to
the depression of the nipples. |
‡A@Confirm the crescentic sheets do not overlap
with the valve. And take the valve off. |
‡B@Crescentic sheets and nipple tapes do not
stick out the outside of the red lines |
‡C@Starting point should be
between 1st and 2nd nipples from valve hole, Ensure that the double sided tape doesn't
become uncentered from the rim center , and at this point it is okay to affix
it lightly as in the image . |
‡D@After affixing it all the
way around, cut it off from the roll using scissors. |
‡E@Affix it while pressing out
the air between the double sided tape and rim. Next, use a utility knife with
a fine tip to cut a hole for the valve. |
‡F@Put the valve through the hole in the
protective sheet, and affix the protective sheet. Ensure that the protective
sheet doesn't become uncentered from the rim center, and at this point it is
okay to affix it lightly as in the image. |
‡G@After affixing it all the way around, cut the
protective sheet once. |
‡H@Press out the air. |
‡I@Press out the air. |
‡J@Please cut the protective sheet with a
utility knife avoiding overlapping. It is okay if there is a slight gap. |
‡K@Affix the double sided tape, hologram
sticker, and protective sheet onto the seam in that order. |
For the rest, refer to the instructions
included with the product.
Finished
Result